1999-2002 Grand Cherokee Driver's Side Mirror (GT3) WJ Grand Cherokee License Plate Bracket. Door Latches for 2003-2004 WJ Grand Cherokee Export Side Marker Lamp. The 1999 to 2004 Jeep Grand Cherokee is a prime example. Our extensive selection of parts for this rig validates this claim.
PART | COLOR | LOCATION |
12 VOLT CONSTANT | PINK/BLACK (+) and RED (+) | IGNITION SWITCH HARNESS |
STARTER | YELLOW (+) | IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | DARK BLUE (+) | IGNITION SWITCH HARNESS |
IGNITION 2 | N/A | IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | RED/BLACK (+) | IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | BLACK/ORANGE (+) | IGNITION SWITCH HARNESS |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | YELLOW (-) See NOTE *2 | @ HEADLIGHT SWITCH, See DIAGRAM |
PARKING LIGHTS ( + ) | DO NOT USE! | |
POWER LOCK | ORANGE/VIOLET and PINK/BLACK (TYPE C) See NOTE *1 | IN BOTH FRONT DOORS, See DIAGRAM |
POWER UNLOCK | PINK/BLACK (TYPE C) See NOTE *1 | IN BOTH FRONT DOORS, See DIAGRAM |
DOOR TRIGGER | See NOTE *3 | |
DOMELIGHT SUPERVISION | YELLOW/DARK GREEN (-) | @ BCM, above DIAGNOSTIC PLUG |
TRUNK RELEASE | N/A | |
SLIDING POWER DOOR | N/A | |
HORN | GRAY/ORANGE (-) | @ HORN SWITCH |
TACH | See NOTE *4 | |
WAIT TO START LIGHT | N/A | |
BRAKE | WHITE/TAN (+) (1999-2003) WHITE/TAN or PURPLE/BROWN (+) (2004) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | LIGHT GREEN/ORANGE (-) See NOTE *5 | @ DRIVERS DOOR LOCK SWITCH in DRIVERS DOOR |
ANTI-THEFT | CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM | TRANSPONDER @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE *1 Use ORANGE/VIOLET for LOCK and PINK/BLACK for UNLOCK at the DRIVERS DOOR SWITCH. Use BLACK/WHITE for LOCK and PINK/BLACK for UNLOCK at the passenger front door switch. This vehicle requires (2) of part # 778 one for each door See DIAGRAM. TO AVOID INSTALLING RELAYS IN BOTH DOORS.... USE INTERFACE MODULE Part # XK09 or DB-ALL. These are combo modules that bypass the Anti-theft and enable the use of keyless entry without adding relays. To make a keyless entry system work you can create the circuit above using (2) #778 realys but it's recommended to use the XK09 or DB-ALL. NOTE *2 the YELLOW Parking light wire will require a (-) Negative thru a 1300 Ohm resistor and a extra relay part #775, to connect, See DIAGRAM. NOTE *3 this vehicle has 4 Door trigger input wires, the DRIVERS DOOR is a TAN/RED (-) at the DRIVERS DOOR LOCK SWITCH, the PASSENGER DOOR is a TAN/RED (-) at the PASSENGER DOOR LOCK SWITCH, the DRIVERS REAR DOOR is a TAN/ORANGE (-) and the PASSENGER REAR DOOR is a TAN/YELLOW (-) both are at the BCM (Body Control Module), when connecting to an ALARM SYSTEM you must BOTH DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *4 on the 4.7L engine, go to any coil and use any wire that is NOT DARK GREEN/ORANGE. On the 4.0L engine, use any wire with a TAN STRIPE at the coil pack NOTE *5 to DISARM the FACTORY ALARM SYSTREM requires a (-) NEGATIVE thru a 463 Ohm Resistor and an extra relay part #775, to connect, See DIAGRAM NOTE***** the BCM (Body Control Module) is located above the DIAGNOSTIC PLUG under the dash. |